connector

Hello all! I am swapping 2019 Rubicon axles into my sport that I got from an engine fire jeep. The locker plug and internal connector was damaged-see pics. I have purchased the external wire and the female to female plug already that goes into the housing. I just need to find the correct plug...

I purchased a new T’eyes CC3 head unit and I’m ready to start the installation. I removed the Uconnect 4 7” head unit and the two panels below it middle (start switch, a/c, radio dials, etc.) and bottom (power windows, usb, etc.) and putting the bottom panel back is where I need help. As plug...

Hi folks, I'm replacing my factory plastic bumper with a Next Venture Motorsports Aluminum bumper that doesn't have provision for fog lights. Not too concerned about that since I'm adding some LP6 Pros to take over their duties, but it does leave me with a dangling unused connector that looks...

Hi, I had my 4.5” long arm lift finally installed and the first stretch I did I broke the differential breathing tube connector to the axle. The tube was not extended longer or relocated. Good to know for anyone installing a lift. I believe this connector is pressed in? Anyone get a new one...

2021 JLUR most packages except front camera and advanced safety group. Noticed a grey four pin (2x2) connector on the left wall in the driver’s footwell when installing a dead pedal. It’s roughly to the back-left and above the OBD-II connector, taped up to a thick wire harness. This photo was...

Did you know the door wiring connectors have a built-in mechanism to prevent the pins from bending? Did you also know that whoever puts the connectors together at the factory hardly ever installs this mechanism properly, hence all the issues with bent pins? If you want to take your front doors...

Hello, I have looked around quite a bit but it seems I cannot find much installation explanation for the Baja Designs XL-R Sport lights. I thought it would be similar to the non-XL Sport lights, but the harness seems to be different and I am not sure what to do to remove the switch properly, as...