What did you do TO your Jeep JL today?

[TTEChris]

I haven’t taken off the rear bottom piece because it seemed like I’d loose the inner liners. How did you retain them?

I mounted the inner liners after removing the fenders and marked where they should be cut. After I cut them, I then put the tabs on the inside rather than the outside for a little cleaner look. It's not perfect, there is still a slight gap at the top. Once the plastidip cures fully I may try to heat up the liners and push them up. I used plastidip because I'm certain I will be switching to aftermarket fenders once a set I really like become available.

Sponsored

 

[Mantacon]

Mounted the hand held. Maybe I'll get less Interference here since it's further away from the radio.

 

[Kenny]

Kind of makes feel like a wimp when compared to what others are doing!

I wish I had done that and stopped - just about every upgrade I have tried i’ve Broken a connector or something worse.

 

[ricardo.cantu]

I mounted the inner liners after removing the fenders and marked where they should be cut. After I cut them, I then put the tabs on the inside rather than the outside for a little cleaner look. It's not perfect, there is still a slight gap at the top. Once the plastidip cures fully I may try to heat up the liners and push them up. I used plastidip because I'm certain I will be switching to aftermarket fenders once a set I really like become available.

Looks awesome, totally going to copy you.

 

[Mantacon]

Realigning the tailgate. Waiting for freaking UPS to get here with my bolts.

 

[Warpath]

So I noticed my JLR had a little "squat" stance toward the rear of the Jeep. So I added 1/2" Terafex spacer in the rear and it leveled it out. I really like the look.

 

[Moto_21]

Made up a little switch panel for aftermarket stuff. Rest of the relay board still being put together so no power on them yet, work in progress! Still trying to find a place to mount the relays...

 

[Pic18]

Had Globex Performance install a Quick Performance exhaust cat back system with cut out. I know guilty pleasure.

View attachment 88826

How do you like it? I watched their YouTube video and it sounds like it would be my favorite exhaust. My only complaint is that in quiet mode exhaust comes out only one side.

I’m curious to hear your feedback. Thanks.

 

[will1111]

I wish I had done that and stopped - just about every upgrade I have tried i’ve Broken a connector or something worse.

Same here

 

[Brew211]

Huge upgrade...

Where did you get that, it is awesome!

 

[Kata]

Kind of makes feel like a wimp when compared to what others are doing!

Size does matter.

 

[Turfman]

Mounted the hand held. Maybe I'll get less Interference here since it's further away from the radio.

That would work great for me since I can only hear out of my left ear!

 

[TXRubicon]

I see this Jeep almost daily when I’m leaving my neighborhood! I’ve been drooling over it for months!

Added window tint, and a couple stickers.

 

[Badger Jeeper]

Where did you get that, it is awesome!

I doctored up some bigfoot clipart I had and cut it out of vinyl on my cutting machine.

I'm trying to decide if he needs some friends. May cut out some happy little trees and add them as well.

 

[sost1sg]

Was cleaning and waxing it and found another Easter egg! This one on the taillight. Jeep grille (lower right)

Sponsored