I sent it back to Quadratec, and since they had a hard time processing an exchange, I ordered another one from amazon...hopefully just a bad batch.
The front sills are straighter, ergo easier, and I got the hang of it (i think), but the pre-cuts were just a bit too big to get a good hand-hold. I’d have to remove the sliders to get access to the lower edge in order to lift/squeegee. Probably easier to use clear packing tape!
Where did you get the mag light holder?
Just did a few additions.
Blackout hood with red trim, matte black USA and Arizona flag in the rear side windows, bartact front storage pouch, Mopar grab handles front and rear sets, fire extinguisher, mag light holder
How long would it take you to remove if you had to use the full cargo capacity? Is it a hinged top?Installed rear deck from jeepbackbone.com
My commute is garage to covered parking so the rear deck will allow me to travel through light rain without putting the hard top on. Also I like the security feature to allow a briefcase or golf clubs to be in the truck and locked. Once my half doors arrive, I plan on extending the deck all the way to the front seat for more of a "truck" look.
Shipping was fast and accurate by jeepbackbone and the product is top notch. I was seriously considering a DIY but when the deck arrived, I'm sure glad I didn't attempt the project.
Nice! were you able to reuse the stock LED foglights?Added the Barricade HD Bumper
Probably 30min to remove. It would come off in 3 pieces with the rear piece easy to remove with two bolts inside the trunk that could be wing nuts, 5 bolts holding the 2 top pieces together. 5 wing nuts connecting the second horizontal piece to the 3rd angled piece behind the rear seats and 2 big nuts securing the angled piece to the rear seat attachments.
Thanks
