Not sure what brackets those would be. They simply lay on the part of the body that the windshield frame bolts to. And they lay on top of the hard top itself above your head. The latches on the panels themselves all hold it in place. It is a very simple system. And only requires the six bolts in the rear.
Sure I have about a dozen bolts for the jeep. And if you ask real nice, I'll include hand removable thumb screws. ;-) Similar to these.
If I recall, there are 4 cast brackets, 2 at the front by the mirror and 2 at the back on sound bar. They need to unbolted and included for anyone with a soft top.
I just went through the soft top installation instructions and there were not mention of brackets. I'll try to find a parts diagram and see if I just missed something.
I'm not at my computer, but the hard top instructions will show the brackets. Dual top will have them but soft top will not. You won't find them in soft top instructions. I'm in the market but you are a little far from me. Just don't want a potential buyer to be disappointed. You'll see the difference if you try to install on factory soft top Jeep.
I just looked at the jeep. There are two bolt-on brackets that the soft top clamps hook into. And the freedom panel clamps also hook into those. But I would assume that a jeep that came with are soft top would also have those??
I have something that looks like G & H in the above diagram. But I would assume the soft top jeeps must have something similar since that is where both the hard top and soft top clamp to. So I would swap with the purchaser if required. If G & H are not the clamp brackets then I should have those and I will include them since I don't think the soft top I have uses them. No worries. Just come buy it, we'll figure it out.They are different. I've attached the PDF in the last post. G,H,I,J in this picture
