Installing Lights on a Warn Elite Bumper

[Frozen Beanz]

I have a 2022 JL Willys on order - as well as a Warn Full Width Front Bumper with Grill Guard Tube on the way — VR EVO 10 Winch will also be mounted.

I am hoping to install (2) 5” or 6” round LED auxiliary driving lights (PIAA LP550 LED or the LP560’s) on the bumper but I can’t find any pictures that show any placement options. I would rather not install them on the guard tube.

Does anyone have any ideas - or better yet - pictures of any lights mounted to this bumper? Much appreciated!

~ Rick M
(cross-posted to TECH/Exterior Mods ….. to catch the bumper crowd)

Sponsored

 

[tk1700]

The bumper has 2 holes on the top on each side of the hoop. Easy to use them to mount lights. Space is limited so you can only get 1 light per side.

 

[Frozen Beanz]

Thanks Tom !

The lights look great - what are they, and what size?

Honestly, I’m not trying to copy you - but looking over some of your comments - I’ve been on a similar build page with you. Just ordered RokBlokz flaps, planning on small spacers to level out sag, saving for Elite Rear Bumper…

You have good taste!

 

[Dave928]

there are 3 pairs of mounting holes if you don't have the tube.

 

[Antonio]

The bumper has 2 holes on the top on each side of the hoop. Easy to use them to mount lights. Space is limited so you can only get 1 light per side.

Hi, was just wondering with this bumper would I be able to use the oem fog lights that are currently on the stock plastic bumper and be able to installed them to the warm elite bumper? Or are the ones shown in your photo a different set, thank you!!

 

[tk1700]

Antonio, They are the factory halogen fog lights in the plastic mount. I did have to trim the mounts to make them fit.

OP, The amber lights are from Amazon and they are 4". Anything bigger would be a very tight fit. I went with amber because I wanted better light for snow.

Sponsored