Halo installation help please

[valentas]

I want to start adding/replacing parts on my JL with aftermarket. I have very little experience when it comes to cars, but I am willing to learn. I would like to buy the Quake Halos. For what I read, the halo has to be connected to the DRLs, but my JL Sport doesn't have the DRL option equipped. So, I looked up alternative ways of trying to connect them, and I read that they can be connected to the fuse box. I was hoping someone could help me figure this out. I'm sorry if I sound ignorant but, like I said, I am willing to learn. Thank you so much!

Sponsored

 

[otisroy]

I have the same situation. From what I understand the bluetooth/RGB controller will power the halos. Do you have the tow package and aux switches? If not, you can use a fuse tap like the link below unless you can find an unused circuit.

https://shop.advanceautoparts.com/p/littelfuse-lp-min-adacrct-10a-fhlm0200zpa/11499058-P

@JLow Rider did a nice write up here on his install:

https://www.jlwranglerforums.com/forum/threads/quake-led-halo-review.16914/

Check out the fuse block diagram by searching for 'jl wrangler fuse diagram' on DuckDuckGo. There's a nice colored graphic and I tried to include a link but it links to a competing forum or something.

I don't have the heated seat package(Central Florida) but the circuits on F57 and F58 are there and ignition powered. I checked it with my multi-meter last night. To piggyback on your question does anyone know if the wires for the heated seats are bundled up somewhere? That would be nice to not have to use the fuse tap.

Edit: removed link to evil site.

 

[thewise1]

I have the same situation. From what I understand the bluetooth/RGB controller will power the halos. Do you have the tow package and aux switches? If not, you can use a fuse tap like the link below unless you can find an unused circuit.

haven't installed them yet but near as i can figure... from post 24 at
https://www.jlwranglerforums.com/fo...-jl-led-headlight-and-fog-lights.11998/page-2
...a Bluetooth controller that allows you to pick which accent color you want to display. Set to white color for on-road use only! If you have a non-DRL JL. Wire the Bluetooth controller to a switch or a existing positive wire that is live when JL is switched on. 12Volts only! The Bluetooth controller autosaves to last set color and will always come back to that color.

Sponsored