ParthianShot
Well-Known Member
- Thread starter
- #1
Obviously I’d need a winch plate, but would this winch fit the stock steel bumper? I searched and can’t seem to find the answer.
Sponsored
Last edited:
What plate did you go with and was it straight forward. Thanks.Yes...
I can’t speak for him, but I mounted my Warn VR-8S to my factory steel bumper with this:What plate did you go with and was it straight forward. Thanks.
Nice, thank you.I can’t speak for him, but I mounted my Warn VR-8S to my factory steel bumper with this:
http://www.rustysoffroad.com/rustys-winch-mount-2018-jl-wrangler.html
It was simple and straightforward, and the total install time for both the plate and winch was probably just over an hour.
just installed mine yesterday. How did you tuck those wires down like that? I know it doesn't make much difference but it looks good and was wondering how you did it. Also where exactly did you route the wires up through for the battery? I've seen differing things. I ran mine over the top sway bar up behind the airbox, then around the battery to connect it.The answer is yes. Installed it yesterday.
Stock curb weight is what, 4500? Being very conservative, you could say 500 pounds for bumpers, winch, and sliders. What the hell are these “misc mods”? You’re over the payload rating at 6000.Hmmmmm......
I am thinking of the 10s. What lead y’all to the 8s?
I thought at a fully loaded rubicon (winch, steel bumpers, aftermarket rock sliders, misc mods, was around 6,000 pounds x 1.5 = 9,000 pounds ...... so 10s. I would love to get the 8s and save some money. Thoughts?
I honestly don’t remember what I did to get the wires that way. I think I just pulled them down from underneath and then zip-tied them.just installed mine yesterday. How did you tuck those wires down like that? I know it doesn't make much difference but it looks good and was wondering how you did it. Also where exactly did you route the wires up through for the battery? I've seen differing things. I ran mine over the top sway bar up behind the airbox, then around the battery to connect it.
I’ll have to try tucking it down more then! The wires didn’t seem to be near any moving parts, we zipped it once it came up by the air box, the ground line and the positive together to clean it up. Was there another component you zip tied it to? Or somewhere else on the way? I’d like to avoid any issues so if ya did I’ll get back in there and zip tie it some more in other places and take your advice!I honestly don’t remember what I did to get the wires that way. I think I just pulled them down from underneath and then zip-tied them.
As far as the route, what you described is exactly what I did. Just be sure to zip-tie along the way so the wires aren’t able to hit the pulley (I made that mistake).
I zip tied it a couple times near the bottom, just to make sure it didn’t have any wiggle room to find that pulley. Other than that, there don’t seem to be any problem areas to look out for.I’ll have to try tucking it down more then! The wires didn’t seem to be near any moving parts, we zipped it once it came up by the air box, the ground line and the positive together to clean it up. Was there another component you zip tied it to? Or somewhere else on the way? I’d like to avoid any issues so if ya did I’ll get back in there and zip tie it some more in other places and take your advice!
Thanks! I see some spots down low where zip tieing it would clean it up! Was your concern with it getting caught in the winch pulley?I zip tied it a couple times near the bottom, just to make sure it didn’t have any wiggle room to find that pulley. Other than that, there don’t seem to be any problem areas to look out for.