rkwfxd
Well-Known Member
- Thread starter
- #1
Dont know how I let this slide but a couple days ago I noticed that the nuts on the back side of my license plate did not match.
I had lock nuts and acorns.
So off to the hardware store I went and got all matching acorns. Had to cut a few bolts but got it all mounted up with blue locktite.
Then I noticed my plate was off center by 1/8th”. So loosened it all up, centered it and retightened.
I think I am still off by 1/64th but Im just going to leave it.
Hopefully no one will notice.
I had lock nuts and acorns.
So off to the hardware store I went and got all matching acorns. Had to cut a few bolts but got it all mounted up with blue locktite.
Then I noticed my plate was off center by 1/8th”. So loosened it all up, centered it and retightened.
I think I am still off by 1/64th but Im just going to leave it.
Hopefully no one will notice.
Sponsored