psdtime
Well-Known Member
- First Name
- Tom
- Joined
- Nov 21, 2019
- Threads
- 12
- Messages
- 335
- Reaction score
- 308
- Location
- California
- Vehicle(s)
- 2005 LJ Rubicon, 2016 Ram 2500 CTD, 2020 JLRU
- Vehicle Showcase
- 1
Isn't it just a bolt in plastic tub? My Borla exhaust melted a corner of the bin (photo), so I don't think there is any metal below the bottom other than some heat shielding. Maybe if the tub was removed, it could be used as a template to make a new one out of metal that is deeper. Unfortunately, I'm not much of a metal worker.Sounds like you'd be the first. Someone with good metal skills could do it pretty quick. Easiest way would be to just deepen it by cutting about halfway down, horizontally, drop the bottom down and flat strap around, weld it up. Or you could find a totaled one in the junkyard and cut it up high and cut yours down lower, add in the taller piece. Half the weld seam.
Sponsored