Ratchet straps for now. In the process of fabing a mount for it.
Fuel Zephyrs. Thank you!
Very nice! This is on my wish list. So what's the review? How was the fit? Is it heavy? Can you install on the ground or do you need a lift?Installed alittle protection. The Quadratec aluminum skidplate.
That trackball bolt on the frame side looks really long versus the one in the kit?Installed front camera.
Installed Midland Ghost 3db antenna on Midland MXT275 (GMRS) so I can now leave antenna on all the time.
Installed Metalcloak front differential cover and skid plate. Powder coated red.
Installed Synergy front track bar brace sector shaft brace.
Everything installed perfectly in minimal time with zero frustrations and never had to get up from the floor for a different tool.......
What was your preventative measure? I'm going to solder mine back on tomorrow.Did my first warranty repair. The rear window defroster solder broke so I fixed it and put a little preventive measure in place to keep it from doing it again. If it does pop the solder again, no big deal as it's about a 15 minute fix.
On mine, once I got it soldered back on and plugged in I noticed that when the window is open the cable appears almost straight from the small black retaining clip to the plug/soldered connector on the window. There was definite tension on the plug. So I took a small zip tie, introduced slack between the small black clip and the plug, tightened the zip tie down, and snapped the cable back into the retainer clip. This keeps any tension between the body and the window and there is not pulling on the soldered plug. My second picture shows the red zip tie and the slack to the plug.
Correct. Synergy sent me correct bolt but the extra nut was for smaller bolt. So I just grabbed a leftover longer bolt from doing earlier mods. A little irritating, but not worth calling them or messing with it. Plus I like the finer threads on metric bolts.
