What did you do TO your Jeep JL today?

[fightingmajor]

The phone has to sit on top of the charger. You could probably fit them in that top tray of the arm rest. I want easier access to my phone though. Thinking I might pick up a more low profile bike mount so it will sit closer to the hand brake.

You can take that wireless charging pad apart and get rid of most of that plastic. You should even be able to find one that would sit under the tray for the center console which would hide everything. If the JL's had wireless CarPlay, this would be the route I would go. But since I have to be plugged in, I'm in the process of rewiring the USB ports to be able to run one up to the trey in the dash for a phone mount there. That way I can share and run CarPlay at the same time.

Picked up this on ebay. It's funny when I bought it, it was supposed to be from Rugged Ridge. Then they changed the name of it after it shipped. No worried though, it serves its purpose.

https://www.ebay.com/itm/Rotation-D...e=STRK:MEBIDX:IT&_trksid=p2057872.m2749.l2649

 

[UKCATS]

Just had some wheels delivered yesterday. Waiting on tires and lift kit to be delivered to the shop before getting them thrown on.

Those are nice.

 

[MrSahara19]

First time Jeep owner here. I am pretty pleased with the look of my Sahara Unlimited and trying to keep the look close to stock (I realize I am in the minority!). So far just some minor changes/additions and have less than$250 in.

- Removed the cheap looking Wrangler Unlimited stickers

- Swapped out for the Rydonair stubby antenna
https://www.amazon.com/dp/B07BDFQDVJ/ref=cm_sw_r_cp_apa_i_gk8nDb917W34F

- Purchased OEDRO Floor Mats
https://www.amazon.com/dp/B07GNCDHD6/ref=cm_sw_r_cp_apa_i_Kj8nDbCTJMCQ7

- Jeep valve stem covers (Wish they sold those in packs of 5...poor spare has to do without):
https://www.amazon.com/dp/B012FQIS1Y/ref=cm_sw_r_cp_apa_i_6k8nDb1AE1VPJ

-Shadeidea Jeep Wrangler Sun Shade JL Unlimited 4 Door Front and Rear 2 piece-Black Mesh Screen Sunshade https://www.amazon.com/dp/B07QQ4V3PB/ref=cm_sw_r_cp_apa_i_gj8nDbDW64RC0

- Had to forgo the Maroon and switch to a Black and White SIU license plate frame.... Added a black bottle opener for good measure (GO SALUKIS!):
https://www.amazon.com/dp/B076HTSRTG/ref=cm_sw_r_cp_apa_i_ui8nDb3VK0M46

- Bunker ind. LED smoked side markers:
https://www.amazon.com/dp/B07QGSC39Z/ref=cm_sw_r_cp_apa_i_Zg8nDbFMQPBBR

-Tried to craft my own hoist for the hard top but had a near catastrophic event. Always check the weight rating as I had a pully snap in two! Will try again..... In the time being I purchased the Mopar touch up paint (68060405AB) for the top :
www.amazon.com/dp/B075LNNF1W/ref=cm_sw_r_cp_apa_i_rg8nDb6B8MXJT

Def love the look of the Rydonair Stubby first mod myself, and smoke side lenses look great, went with the clear ones on the sting gray - also going back and forth on the clean vs modded look - Did you do black Jeep badges? Also thinking about plasti dip the front fog covers to black.... Jeep is clean man - def following

 

[RubenZ]

Finally got around to installing my 2.5" Rancho Lift and Front & Rear Rock Krawler Adjustable Track Bars. All I need left to do is grease the Track Bar, drive it a bit, re-Torque everything and I'm good to go.

Next step will be 35's. Although I may just wait to wear out these 33's. Maybe once I add the bumpers, winch, etc the wheel gap may not be so noticeable.

 

[DaddyEngineer]

You can take that wireless charging pad apart and get rid of most of that plastic. You should even be able to find one that would sit under the tray for the center console which would hide everything. If the JL's had wireless CarPlay, this would be the route I would go. But since I have to be plugged in, I'm in the process of rewiring the USB ports to be able to run one up to the trey in the dash for a phone mount there. That way I can share and run CarPlay at the same time.

Picked up this on ebay. It's funny when I bought it, it was supposed to be from Rugged Ridge. Then they changed the name of it after it shipped. No worried though, it serves its purpose.

https://www.ebay.com/itm/Rotation-Dash-Tray-Mount-Phone-Holder-For-Jeep-Wrangler-JL-2018-2019/223488387982?ssPageName=STRK:MEBIDX:IT&_trksid=p2057872.m2749.l2649

That’s what I did with my JK when I put in the after market radio.

 

[J.boyd919]

Those are nice.

Yeah I’m pretty stoked. I took my damn time picking them out too. I flip flopped between like 8 different wheels. I really like how they look in person. Just waiting on the rest of the kit to get in. 2.5 inch Rock Krawler adventure series lift and some Dick Cepek Trail Country EXT a/t 35s.

 

[Memphis Peej]

Cool table! Which one is that?

It is made by Frontrunner. Very nice quality but if you purchase one, take the instructions and burn them.

Trying to follow their instructions was like trying to ride a meth'd up rhino being attacked by killer bees.

 

[Runt]

Light bar mount installed this morning. Will install lights tomorrow.

 

[Amansurpro]

I put the leather dash from the JT launch edition in my JLUR.

Looks great!! I wonder if this would work in the JL Sport S?

 

[PapaJoe]

It is made by Frontrunner. Very nice quality but if you purchase one, take the instructions and burn them.

Trying to follow their instructions was like trying to ride a meth'd up rhino being attacked by killer bees.

 

[BernJLUR]

where did you get the lights are they water proof....they look awesome

Bought on Amazon. Here's a screenshot. Someone here on the Roam thread recommended them.

 

[Ehmsea]

Added PRP Seat Covers. These things look fantastic!

I am really impressed on how FCA managed to make the JL's interior feel high quality yet somewhat luxurious while still resembling simple and functional. But I felt the black interior was just too much black, making individual details irrelevant because it was so dark. So I went with the gray tweed to lighten the cabin, bringing more contrast between the fabric elements and the hard elements. Combined with the body colored dashboard, the interior feels much more balanced. It's mature, pleasing and cheery. Every detail seems more noticeable now that there is separation between the colors and textures.

This is truely unique...looks great

 

[BernJLUR]

My JLUR had its first growth spurt. Mopar 2" lift kit installed. Kit had the new perches so minimal to no bowing. I have steel bumpers and steel Roam rails so I think I netted closer to the actual 2" versus the 3+ many have reported. Lastly, driveability remains good without any wandering.

Unfortunately DTD sent me the wrong color Fuel Vectors so we will have to wait another week or two before we add those.

 

[melendez69]

My JLUR had its first growth spurt.

 

[BettyBoop]

What a nice surprise from my UPS driver tonight. New ARB Snorkel. Ordered a couple months ago; last check they weren't going to be produced till Aug. I'll post pics once it's installed. This weekend? Hopefully.[GALLERY=][/GALLERY]