What did you do TO your Jeep JL today?

[AnnDee4444]

I sure do MadDog27. If I can get them uploaded correctly Lol we'll see. Hope they help !!

Any drone with this setup?

 

[jeepster345]

So I have a Turbo 2.0 Engine . You saying a 3.6 Engine Cluster will not work on Turbo 2.0 ?

You wouldn't have an issue with the actual cluster, but rather the tachometer dial would have the incorrect redline. You could possibly find someone selling just the correct dial for your engine on Ebay, but I don't like the idea of opening up the cluster and damaging the internals. If you were to buy the entire cluster, you would have to check the engine from the source vehicle and what trim the source vehicle was, based on whether you wanted the orange or red trim. I just looked on LKQ and they have a cluster for a 2.0 Turbo in MPH, with the orange ring and 7.0 inch screen. Here's the link: https://www.lkqonline.com/2019-jeep-wrangler-speedometer-head-cluster/-h334mjcFOm/-i~269360194

My cluster had 0 miles on it and it came out of Denver. I think several Jeeps were damaged during transit out there and they all ended up in the same junk yard.

 

[beast40]

I did this to my last JL and it was awesome.

I had clear door edge guards installed around the entire trim of the door. Most importantly the bottom of the door, so when I take the doors off they rest on the plastic trim instead of on the paint.

Its hard to see in the pictures but there is a clear film on the edge. (you can see the rounded edges at the end of each lenght of material)

 

[Larrymuld]

I installed these bags.
https://www.ebay.com/itm/303625773339
The installation was pretty straightforward and they provide an easy storage solution for some dead space. In the drivers side bag I have bubba ropes 3/4 in 30ft tow rope.

 

[Roky]

Played hooky this afternoon and got my Poison Spyder rocker guards on. Time consuming but not that difficult. I like the look. The wife says it looks more off-roady,........

 

[hoag4147]

Played hooky this afternoon and got my Poison Spyder rocker guards on. Time consuming but not that difficult. I like the look. The wife says it looks more off-roady,........

Looks great

 

[Roky]

Looks great

Thanks brother.....

 

[WRGLR-JL]

What are you talking about?

The Rubicon and Sahara clusters are literally EXACTLY the same except for the 2 circle lines and needle are slight more orange in the Sahara and its slightly more red in the Rubicon. Sport has totally different cluster however.

Please, enlighten me on what other difference you noticed.

Not sure what you're going on about. It's a matter of taste. If you don't see enough of a difference then that's great for you.

 

[Jay 13]

Played hooky this afternoon and got my Poison Spyder rocker guards on. Time consuming but not that difficult. I like the look. The wife says it looks more off-roady,........

Oh it’s “off-roady”

looks great brother

 

[WRGLR-JL]

I picked up the Bestop Sunrider today from Just For Jeeps and installed it, I absolutely love it. I have not tested for leaking but we are getting a lot of rain Sunday so we shall see. The wind noise is not issue at all over the freedom panels. Easy install. I put the unit together first then installed in on the Jeep by myself. I am going to take off the little Bestop stickers but I did not yet.

This fits in the back of the JLUR in case you need to pick one up.

Freedom panel removal

The top installed and closed

Please update after Sunday regarding water tight seal. Very interested in one of these.

 

[Chupacabra]

Changed the oil/filter (4,200 miles), change diff fluid front and rear (front looked new, rear was pretty grey and nasty looking), and did 5-tire rotation.

 

[jlroman2]

Played hooky this afternoon and got my Poison Spyder rocker guards on. Time consuming but not that difficult. I like the look. The wife says it looks more off-roady,........

Super clean. Looks awesome!

 

[Fonzilla85]

Busy day in the garage today. I finally installed the Motobilt rear bumper on my rig. As well as the GP factor license plate relocation bracket. Overall it was a smooth install. Also got around to installing the CoolTech fire extinguisher bracket. Only issue was me, I haven’t wrenched in a while so my organization left a lot to be desired.

 

[MacombRoger]

So I have a Turbo 2.0 Engine . You saying a 3.6 Engine Cluster will not work on Turbo 2.0 ?

You always have this option too:

https://www.usspeedo.com/product/daytona-edition-custom-gauge-face-for-2018-jeep-wrangler-gas/

They go to many Jeep shows and will replace it for you on site usually for little to no cost. Of course you can do it yourself too.

 

[mazer]

...I like the red over the orange and that’s good enough for me.

Your upgrade is abundantly commendable for the "didn't know you could do that" factor alone.

I am aware that the tit-for-tat has run its course already. But honestly, I have to give you kudos here. Many of us spend well above the cost of your cluster swap-out on things just because we "prefer" things a different way. I have a bright white JL, and have gone to extremes to remove anything orange, red, amber, grey, silver or chrome - and it's been just because I like it better that way.

Hat tip to you for the pursuit of "the way you like it."

Sally forth.