treoguy
Well-Known Member
- First Name
- Chris
- Joined
- Jun 22, 2020
- Threads
- 9
- Messages
- 111
- Reaction score
- 166
- Location
- Long Island, NY
- Vehicle(s)
- 2018 Jeep Wrangler JL Sahara
Replaced the silver fog light bezels on my Sahara.
Since the fog lights are closer to center, Did you have any issue having the plug from the fog lights reach the main plug?It’s new bumper day!!
No, I just had to swap the connection to the rest of the harness from the outside of the frame rail to the inside. Not that big a deal. However I forgot to do it before I put the bumper on and I couldn't fit it under the grill. So I had to remove the grill just to move it from one side to the other. Not that big a deal but would have been better had I remembered to do it before installing the bumper.Since the fog lights are closer to center, Did you have any issue having the plug from the fog lights reach the main plug?
I've had Amazon say many times "Not compatible" for something that was 100% compatible. Their tool is not most accurate. I'd verify with the seller. They may need to update the compatibility data as well.Thanks. I was actually looking at the beamtechs last night and I have seen good things on here, but Amazon says they don't fit my jl.
Added some 7” led lights in the bumper ends and wired them to my RC MLC6 controller. Used disconnect plugs in case I want to take ends off for stubby. Great lights for the moneyNew Smittybilt Stryker front bumper. Love the look. I’ll be adding lights to it and a winch in near future.
To me that looks so much better. One of the reasons I went with the Altitude edition. Blacked out look.Replaced the silver fog light bezels on my Sahara.
Was it difficult to apply? I know nothing about ceramic coatings? I guess I will have to search for a thread.Installed ceramic coating on full wrap ppf! Stuff feels nice and easy to apply.
Like the single 7" light. Well done, and hopefully helps others find a set up they like in those caps too. Surprised S/B doesn't have something that fits perfectly in there specifically for that bumper. Seems some standard lighting with some plastic housings for those caps would sell every time they sold one of those bumpers. Thanks for sharing.., looks great.Added some 7” led lights in the bumper ends and wired them to my RC MLC6 controller. Used disconnect plugs in case I want to take ends off for stubby. Great lights for the money
from what i read its all about the cure times. I figure its no worse than doing a normal hand wax. Just ordered myself the Chemical Guys ceramic wax to try it out. gonna pick up the polish in hopes to get ride of some of the desert pin strips i haveWas it difficult to apply? I know nothing about ceramic coatings? I guess I will have to search for a thread.