What did you do TO your Jeep JL today?

[OnlyOne]

That’s so cool, did they grow up together, looks like they been together for a long time.

No, we got Steve the Maine Coon when Rubi the GSD was 3. Steve was just a baby. Maine Coons are fearless and act like dogs and Rubi respects that. They are buddies.

 

[klhjeep2018]

No, we got Steve the Maine Coon when Rubi the GSD was 3. Steve was just a baby. Maine Coons are fearless and act like dogs and Rubi respects that. They are buddies.

Adorable!!!

 

[obwahn]

No, we got Steve the Maine Coon when Rubi the GSD was 3. Steve was just a baby. Maine Coons are fearless and act like dogs and Rubi respects that. They are buddies.

Freaking awesome!

 

[Larrymuld]

I put together my air compressor kit.
https://www.jlwranglerforums.com/forum/threads/my-air-compressor-kit.47388/

 

[Kripas]

Mounted Recovery Track by X-Bull $60 using pack strap $14 and bicycle lock $12

 

[K.O.M]

38s
NO LIFT.
NO DOORS.

 

[AlamedaJeep]

Mounted Recovery Track by X-Bull $60 using pack strap $14 and bicycle lock $12

Hey, I'm near you and your Jeep should be easy to recognize, especially from the back.

I'll be the one waving AND honking!

 

[Drytellsr]

Quite an eventful few days in Jeep modding, so this is a bit of a wrap up.

Full PremiumShield Elite SH Paint Protection Gloss Wrap & Hood Flare
Rugged Ridge Elite Headlight Guards
Vector OffRoad Full Width E-Dock
67 Designs Phone Holders x2
GPCA GP-Grip PRO x2
Rubber tubing to close gap between fenders and body

Keep an eye on the rubber tubbing, I have to continuously tuck it back in. You may want to go just a little deeper

 

[RagTopDeluxe]

We took the winch off today. What a pita, but one more step in going back to stock. I can’t wait to be be done with this Jeep and hope the next one is good.

 

[obwahn]

We took the winch off today. What a pita, but one more step in going back to stock. I can’t wait to be be done with this Jeep and hope the next one is good.

FWIW, all the best to you gurl!

 

[Jeep Generation]

Added some Amber light!

 

[ColoJLRubi]

That looks great! Any reason in particular you retained the lower trim on the fender flare? Asking bc I’m awaiting the AAL liners, but have begun work to remove the flares and plastic liner in prep. I think I will remove the lower trim. I’m curious how you removed the factory liners without screwing up the plastic fasteners / rivets that line the lower trim piece on the flare?

No reason except I hadn’t seen it done yet and so I wanted to wait. You just use your trim tool and pop off the liner from the inside. Some may be to loose to keep it this way but I didn’t pay to close attention.

The instructions are ok, I had Brit call me because I wasn’t quite sure about a couple things, They may revise them just a bit to make them clearer.

 

[RagTopDeluxe]

FWIW, all the best to you gurl!

Thanks! It’ll be worth it all when I’m driving a Jeep that can steer correctly and we can use it as God intended—on the trials and take the dog to the beach and mountains.

 

[03Indigo]

Can you provide some info about the kit you used? Where to purchase?

ebay, Do a search for Jeep JL Rubicon front fenders. There are a ton of “unbranded” options. The lights and fender liners and mounting hardware were all included, both sides for under $300 shipped.

 

[03Indigo]

So you did the aftermarket flare kit from Mopar it sounds like. So no additional wiring to your Sport harness? Just needed to enable LED DRL options and all worked. Thanks

no, an unbranded eBay kit, but no additional wiring needed, just direct plug into the harness on the Jeep, same fittings. Just did jscan mods. Lights have a sequential turn signal, it has a “hick up” every now and then, but goes away after a second. I’m looking into that. But otherwise it’s perfect.