What did you do TO your Jeep JL today?

[Nikko2020]

Also bought a 90 degree left USB adapter so I can route my USB closer to the dash, and close the media flap a little further.

Have you thought about using the one in the console? I drilled a small hole in the side of it and run the USB cord out of the console and next to the drivers seat where the E-Brake is. My phone sits in there plugged in and keeps everything nice and neat. Just a thought ...

 

[Saddle Tramp]

Installed some lights on the front bumper. I found them on Amazon it was a really nice kit even came with a wiring harness including a relay and fuse. I didn't use the harness sine I had pre-wired before they arrived.
Hopefully tonight I will get the rear bumper off and install the Orical back up lights

 

[EXPFDR]

Tell me about these headlights. they look interesting.

Thanks, I love the look of them. I got them from Rough Country. Real easy to install, basically all plug and play. Only thing I haven't done yet is connect the switch back halo turn signal. The instructions were vague on where those wires are. Would feel better soldering wires instead of supplied T taps once I find them. Also very bright high beams.

https://www.roughcountry.com/jeep-led-headlights-rch5300.html

 

[From0toJ]

thinking of putting a new axle back muffler system to make Big Red a little more rumbly. Any ideas? I was thinking of a Magnaflow exhaust

Just to share my experience…. I “thought” I wanted the same thing. Bought an aFe power exhaust, it stayed on for one startup and drive. Took it off and shipped it back and went back to stock. Jeeps aren’t meant to be loud, except for the 392.

 

[Teamjlred]

thinking of putting a new axle back muffler system to make Big Red a little more rumbly. Any ideas? I was thinking of a Magnaflow exhaust

More of a Growl then a rumble. Bit aggressive on cold start but smooth tone after warmup w/ the Turbo spoilling.
Vid sounds best w/earbuds.
https://www.jlwranglerforums.com/fo...ou-do-to-your-jeep-jl-today.3033/post-1380398
https://www.jlwranglerforums.com/fo...ou-do-to-your-jeep-jl-today.3033/post-1381344

 

[Wightmn]

Time to put the hard top back on. The new headliner really finishes off the interior nicely. Sound deadening made a big difference as well. Worth the effort.

 

[Bubsjeep]

More of a Growl then a rumble. Bit aggressive on cold start but smooth tone after warmup w/ the Turbo spoilling.
Vid sounds best w/earbuds.
https://www.jlwranglerforums.com/fo...ou-do-to-your-jeep-jl-today.3033/post-1380398
https://www.jlwranglerforums.com/fo...ou-do-to-your-jeep-jl-today.3033/post-1381344

I used rumble cause couldn't think o what to call it. Throaty maybe, I like the growl

thanks by the way

 

[Rockstar08]

Time to put the hard top back on. The new headliner really finishes off the interior nicely. Sound deadening made a big difference as well. Worth the effort.

Looks so much better than the white!! What headliner is that?

 

[chris_tofu_r]

Mojave/Diesel light brackets with KC LED Cubes, Mopar Performance Rock Rails, and the prior generation silver Rubicon hood decal

 

[Rock Hopper]

I used rumble cause couldn't think o what to call it. Throaty maybe, I like the growl

thanks by the way

I went with the magnaflow dual tips. 100 percent satisfied with the sound, look and quality.

 

[Kripas]

Installed some lights on the front bumper. I found them on Amazon it was a really nice kit even came with a wiring harness including a relay and fuse. I didn't use the harness sine I had pre-wired before they arrived.
Hopefully tonight I will get the rear bumper off and install the Orical back up lights

What brand is that?

 

[Saddle Tramp]

What brand is that?

Here is a link to the site
https://www.amazon.com/dp/B09335991K?psc=1&ref=ppx_yo2_dt_b_product_details
They seem to be pretty well built

 

[RubiGrey]

Installed the TrailRax kit and the RotoPax mounts and containers.

overall, pretty easy install. I’ve seen some people get paint damage so I added some strips of foam for protection.

doesn’t seem to rattle either.

I put the gas RotoPax on the driver side, so if I need to fill it, I can fill it at the same time as my Jeep without having to take the Pak off.

 

[blnewt]

Welded up a couple front LCA skids, now I'm fully "skidded" except for the rear LCAs which are getting braked at the machine shop this week, should have them on next week.

Had some extra plate from my skid plate project so I thought might as well get everything done.

Knowing my luck the only thing I don't protect will take a one in a million rock injection at just that point

 

[Bubsjeep]

Looks so much better than the white!! What headliner is that?

yes what is that?