I will have to respond with a picture of the switch and the box.pics of the rough country switch panel. how easy was it to install. what baja grsign lights are you running on the a pillar. also what pattern.
Johnny,Hi Stephen, does the decal go under the squirters or around them? Looks great in any case.
My thoughts exactly. I was irritated enough that I didn't contact them. I'm going to soak the locks in some lubricant and see if they work again, but they're not going back on.Oh that's just f*cking great. I ordered them last week... I figured I'd give them a try.
For damn-near close to $200, I wouldn't expect that. Did they have anything so say about it?
Looks excellent. How would you rate the difficulty of install 1-10? (10 being most difficult)Didn’t do it today but on Wednesday, threw the hood decal on (thanks @pixeldecals for the great design). Used an old credit card to get the air bubbles out; may have scraped too hard and nicked a few spots but we’ll just call them faux battle scars. Shout out to @chevymitchell for lending me some Rapid Tac so I could position the sucker!
Maybe a 2? I’m kind of new to doing mods on my Jeep. For me, removing the hood insulation liner was pretty annoying because it almost starts to crumble and I pretty much broke every retention clip. Using Rapid Tac helped a lot with allowing me to place the decal and pushing air out before it started sticking. The hardest part was getting the edge to conform to contoured front of the Rubicon hood (which is called out in the instructions. Just be patient when you do it.Looks excellent. How would you rate the difficulty of install 1-10? (10 being most difficult)