What did you do TO your Jeep JL today?

77RRAD

Well-Known Member
First Name
Ron
Joined
Feb 24, 2019
Threads
9
Messages
159
Reaction score
517
Location
Las Vegas
Vehicle(s)
2019 JLUR
Vehicle Showcase
1
The install looks clean and high enough to clear most skid plates. It does look like we could use a little more of the OEM type heat shield mats above parts of the new exhaust system, is there room to fit those in without removing the exhaust? Especially important for those of us in Hells Acres...(AKA Arizona)
The muffler sits about 1" to 1 1/4" higher then the frame and you have about the same above it.
If you look even with the bottom of the frame you cannot see any part of the exhaust. Exit point too.
I live in Las Vegas so know about the heat!

Ron
 

Yellowssm

Well-Known Member
First Name
Ray
Joined
Apr 11, 2020
Threads
6
Messages
245
Reaction score
798
Location
Las vegas
Vehicle(s)
JLUR
The muffler sits about 1" to 1 1/4" higher then the frame and you have about the same above it.
If you look even with the bottom of the frame you cannot see any part of the exhaust. Exit point too.
I live in Las Vegas so know about the heat!

Ron
Im in vegas too. I’d like to hear it before I order One. do you mind?
 

Den_JL2DR

Well-Known Member
First Name
Den
Joined
Apr 6, 2020
Threads
5
Messages
49
Reaction score
109
Location
Arizona
Vehicle(s)
2020 SportS 2DR 6 Cyl Hardtop

melendez69

Well-Known Member
First Name
Marc
Joined
Jun 22, 2018
Threads
29
Messages
3,158
Reaction score
5,918
Location
Waxhaw NC
Vehicle(s)
2018 3.6 JLR / 2013 911 / 2013 E92 M3
Occupation
...huh?
Vehicle Showcase
1

m3lover1

Well-Known Member
First Name
Ricky
Joined
Jun 9, 2019
Threads
15
Messages
619
Reaction score
1,518
Location
Bay Area, CA
Vehicle(s)
2019 Sting Gray JLUR, 2007 Yamaha R6
Over the weekend helped my uncle install Steersmarts tie rod and drag link on his JT, as well as Synergy's sector shaft and trackbar brace. It's in the shop today for alignment, axle truss install, and regearing.

For mine I retorqued my tie rod and draglink ends, and also installed Synergy's brace. My KC Hilites amber fog lights were also wonky, as my passenger side was dimmer than the driver side. Northridge advised me to swap them left and right to see if it was due to harness issue. I did so, and it worked originally, but now one of the lights is out lol. Warranty time.

20200601_155001.jpg


20200531_212343.jpg
 
 
Top