What did you do TO your Jeep JL today?

[Movingday]

I like that idea! Does the front bumper fit it if you drive into that?

I haven’t tried. Will look at it later and let you know

 

[Movingday]

I like that idea! Does the front bumper fit it if you drive into that?

Went out and tried. It doesn’t fit inside. Luckily my garage is deep enough I don’t need it too.

 

[liquids]

Went out and tried. It doesn’t fit inside. Luckily my garage is deep enough I don’t need it too.

Appreciate the effort. Thank a lot!

 

[TTEChris]

Installed my Wifes wheel/tire setup(17x8.5 ProComp 5034, and 35x12.50r17 Goodyear Fierce Attitude)
Also installed the Mopar reinforcement plate and RC relocation bracket. I cut a hole in the Pro Comp center cap for the camera to poke through.

 

[JEEPJL]

Installed my Wifes wheel/tire setup(17x8.5 ProComp 5034, and 35x12.50r17 Goodyear Fierce Attitude)
Also installed the Mopar reinforcement plate and RC relocation bracket. I cut a hole in the Pro Comp center cap for the camera to poke through.

Thats an Impressive Rig !!

 

[Calijeep]

Got the Jeep tinted. 50% on the windshield, 15% on front doors and rear glass and 20% on the rears

 

[dhutcheson]

Installed my LOD front bumper and Warn Zeon 10s Platinum

 

[DanW]

Installed my LOD front bumper and Warn Zeon 10s Platinum

I like that Factor 55 hook! I just received their Splicer today. I'm going to put it on tonight.

 

[RussJeep1]

Today, based on excellent advice I read here about hard top's two back hose holder device getting in the way of the soft top closing, I gently removed it, put it in the tub and covered the hole with electric tape.

When I put the soft top on I'll connect the two back hoses to this piece in mid air.

 

[FrenchSSGTMike]

Got the Jeep tinted. 50% on the windshield, 15% on front doors and rear glass and 20% on the rears

Huh, that sounds kinda dangerous at night on pitch black roads, and probably very illegal, but it’s just me...

 

[Gaxmode]

It’s the little things that count

 

[FrenchSSGTMike]

It’s the little things that count

Did the same on mine, had a hard time removing the dip from around the Saharas without damaging it, how did you do it ? Wait a long while, or removed it right away ?
How many coats did you put ?

 

[Gaxmode]

Did the same on mine, had a hard time removing the dip from around the Saharas without damaging it, how did you do it ? Wait a long while, or removed it right away ?
How many coats did you put ?

I actually removed the painters tape and placed it about 2 inches above the Sahara. That way it gives you room to peel it off. For the hard to reach area I just used a toothpick.

 

[Gaxmode]

I waited about 30 minutes.l after the last coat. Roughly 3-4 coats. I was spraying it in between adding some vinyl decals.

Honestly when I was peeling near the Sahara letters I would just try to rip it. I did have to redo a few letters twice.

 

[FrenchSSGTMike]

I waited about 30 minutes.l after the last coat. Roughly 3-4 coats. I was spraying it in between adding some vinyl decals.

Honestly when I was peeling near the Sahara letters I would just try to rip it. I did have to redo a few letters twice.

I did the same (tape about 2 inches away)
You redid the few letters while you were removing it ?
I’m considering removing it all and starting all over, but redoing a few letters would be easier