What did you do to your 2dr today?

[JLR_AEV]

This is quite interesting. I have toyed with the idea of fabricating a small table that would hang from the passenger grab bar. Eliminating the need to rest it on your lap. That gets uncomfortable for me (restless legs).

I was looking into that too. I feel like those 2 screws on the grab bar would be perfect to set up some mounts but I didn't find anything remotely related

Sponsored

 

[dragoneggs]

I was looking into that too. I feel like those 2 screws on the grab bar would be perfect to set up some mounts but I didn't find anything remotely related

Yep, no doubt a custom fab.

 

[AncientCityJL]

Just finished up my Genesis dual battery install yesterday.

Looks like I'm going to have some trouble with the Rugged Ridge snorkel plumbing.
Wired the G-screen upside down. Yep, I did that. Wasn't a big deal to make it right. I wired it above the rear view so I could see it and access it easily from the driver's seat. I can use it to monitor onboard air and both batteries. I can also use it to run the batteries in isolation or parallel.
I made sure to wire the Rugged Radio directly to the aux battery (Genesis bus) so it's not keyed. That way I don't need the vehicle to be on to use it in emergency.

 

[AncientCityJL]

Here's a pic of the G-screen in its final install location above the rear view. You can also see my filthy fingerprints all over everything. It was beer-thrity last night when I finished and I was in a hurry to snap some pics and get inside to my wife, the puppies, some hot chow, and cold beer.

Oh, and I also put in some Smitty Bilt seat covers

 

[1995YJ]

Install some new KBD fender flares and wheel liners

 

[amalgamatedzen]

Found an urban RTI ramp to test my fender clearance on the 38's. Pretty sure rear fender liners would allow me to reduce the bumps and gain back 2-3 inches of usable travel.

 

[zsg1313]

Got my JK Poison Spyder bumper installed after more hassle than planned

 

[Swisskidd]

Got my JK Poison Spyder bumper installed after more hassle than planned

Had one of them on my JK as well. Superb quality product. Should’ve kept it.

 

[Krondor]

Replaced the ball joints after 47k miles, and was amazed at the difference it made.

Seriously, it's a good idea to replace the stock joints as soon as possible.

 

[Swisskidd]

Replaced the ball joints after 47k miles, and was amazed at the difference it made.

Seriously, it's a good idea to replace the stock joints as soon as possible.

Should I be concerned about my eyesight, or do I see two zerk fittings??

 

[Krondor]

Should I be concerned about my eyesight, or do I see two zerk fittings??

Yeah, the Teraflex joints have zerks to grease at every oil change.

 

[amalgamatedzen]

Installed some 392 paddle shifters I got for Christmas. I think I will really like these for low speed crawling where I want to keep my paws on the wheel.

 

[J.Ferreira]

Installed the Voswitch JL400 that I saw another member had posted before, ran into a snag where the button module was missing it's lower clip! Trying to get in touch with customer service, but since it's a weekend I'm guessing I won't get a response till tomorrow.
Installed some spot/flood lights at the bottom of the A pillars as well.
All in all very satisfied with the Voswitch kit, just hoping the customer service comes through!

 

[Killerbell]

What lights did you go with

Installed the Voswitch JL400 that I saw another member had posted before, ran into a snag where the button module was missing it's lower clip! Trying to get in touch with customer service, but since it's a weekend I'm guessing I won't get a response till tomorrow.
Installed some spot/flood lights at the bottom of the A pillars as well.
All in all very satisfied with the Voswitch kit, just hoping the customer service comes through!

What lights did you go with?

 

[J.Ferreira]

What lights did you go with

What lights did you go with?

Nilight LED 4" spot/flood combo lights.
I got the kit with the entire wiring harness, which ended up being a mistake, but all is well.
https://smile.amazon.com/dp/B07SFG7GN9?psc=1&ref=ppx_yo2ov_dt_b_product_details

If you need the button switch and the relay then it's a good buy, and the lights themselves are very bright and work well. I just didn't actually need the relay and the button, just the wiring itself.

Sponsored