Warn Zeon relocation kit on a Mopar steel bumper

[Consumer]

Has anyone relocated the solenoid on a Warn Zeon using a Mopar steel bumper? What I'm trying to figure out is can the OEM cover plate be put back on to completely cover the winch? I assume you need to clock the clutch handle 90 degrees so it's down below the surface of the bumper. I know with the AEV bumper on the JKs you could do this and the install looked super clean (see below).

Sponsored

 

[JPAloha]

Theoretically possible to reinstall the cover plate if the solenoid wasn’t there. However I can’t see how you’d access the clutch handle without cutting a hole in and therefore weakening the mounting plate.

It’s pretty discreet installaction anyway and using the Maximus 3 filler plates tidies it up quite a bit.