Murphydog
Well-Known Member
Good evening all - so today was the big day, swapping from plastic to steel front bumper and installing the VR EVO 10S. I purchased the bumper used off of these forums and had to transfer over the fog lights.
- I used the Maxis 3 brackets to mount the fog lights from the plastic bumper. They worked like a charm, though I need to confirm I don't have em upside down. Getting the wiring harness out of the plastic bumper took some time, and we were not 100% sure how to attache it to the steel bumper, but we sorted through it
- That said, the fog lights look really exposed from the rear? Anybody else have that issue or concern?
- Fitting the steel bumper back on was a struggle, thankfully my neighbor was able to slam it on while I pushed the winch and plate up at the same time
- The VR seems pretty solid, however the wires come out the back, so they are pressed tightly to the Jeep just below the grill, I suspect this is going to rub the paint off. I wish it sat 1/2 forward on the warn winch plate. Anyone else have this issue with the VR ?
- The supplied hardware didn't work for the fairlead, picked up some new bolts tonight and will install in the morning.
Sponsored