Dk3121
New Member
- Thread starter
- #1
I bought some Rubicon axles a while back and quickly looking them over everything looked right. When I got around to installing them I found out the rear axle had the lower control arm brackets cut off and moved about 2" out. I have been on a rough country 3.5" lift for 2 years with no issues but with this unexpected bracket movement they don't line up. Is there a control arm or a relocation bracket for the frame side to where I can get this to work? I don't have a welder or the experience to put them back in the original location and there are almost no shops around here that I know of.(mid state Illinois) Any help or info would be greatly appreciated.
This is going on a 2018 JLU sport S, the front axle is on with no issues.
The 2 pictures you can see 1 side is upper and lower are in. The other side there is no way it is going to fit. I also measured it and its overall about 4" wider, so 2" on either side.
This is going on a 2018 JLU sport S, the front axle is on with no issues.
The 2 pictures you can see 1 side is upper and lower are in. The other side there is no way it is going to fit. I also measured it and its overall about 4" wider, so 2" on either side.
Sponsored