kapk22
Well-Known Member
- First Name
- Kasey
- Joined
- Apr 19, 2020
- Threads
- 169
- Messages
- 973
- Reaction score
- 433
- Location
- San Antonio Texas
- Vehicle(s)
- 1990 YJ, 2021 JLUR
- Thread starter
- #1
Today I started the wiring the amp power steps according to the instructions. When I plugged the fuses into the wiring harness, the left rear turn signal went out, power door locks and entry lights don’t work when opening the doors. I am thinking it might be that the plug from the front passenger door into the harness did not clip in all the way. However, why would this affect the turn signal?
The instructions use posi-taps to splice into the vehicles corresponding wires up under the passenger side kickpanel. See the pics below.
I am planning on pulling all the wires back off tomorrow and stating over. Any ideas?
The instructions use posi-taps to splice into the vehicles corresponding wires up under the passenger side kickpanel. See the pics below.
I am planning on pulling all the wires back off tomorrow and stating over. Any ideas?
Sponsored