Chipe
Well-Known Member
- Thread starter
- #1
Today I installed the Synergy upper and lower adjustable control arms. Took me about 2 hours for all 4. Then I attacked the front track bar brace and sector shaft brace. What. A. Nightmare. Seriously. They use 2 different sized hex key bolts, one metric, one SAE, two different sized metric bolts and nuts, and if you are not really, really careful the holes do not line up properly. You will end up taking it off, realigning, trying again, realigning, rinse, repeat. Then, if you are like me, you will try to put a non-Synergy track bar in (I have Teraflex) and it doesn't fit in the brace with the lower frame side bolt in, so you have to take that out and realign, again. It took me from 3 this afternoon to 8 tonight just to put this brace on and get my track bar reinstalled. Sheesh.
Tomorrow I have the tie rod and the drag link. The OEM parts are already out, so it should go pretty quick.
Wish me luck.
Then Friday 4 wheel alignment.
Tomorrow I have the tie rod and the drag link. The OEM parts are already out, so it should go pretty quick.
Wish me luck.
Then Friday 4 wheel alignment.
Sponsored