texastonka
Well-Known Member
- Thread starter
- #1
On stage 1 of my JL build I'm installing a 3.5" GC Metal Cloak lift with six packs. Plan to run 38x13.5r7 Patagonia MT on ATX AX194 RAVINE 17 X9 (-12 offset) so that should be a 4.53 backspace.
I'm assuming these will fit without rubbing for the short term I'll have them, just need to dial in the bumpstops.
I will be going with 72" XD60's front/rear later with 40" tires on 17x8.5 wheel with 5 or 5.5" BS as phase2 with inner fender cutouts by American Adventure Lab and Artec inner fenders.
Will be running these 38's for a few months up to a year, see any issues with this set up?
I'm assuming these will fit without rubbing for the short term I'll have them, just need to dial in the bumpstops.
I will be going with 72" XD60's front/rear later with 40" tires on 17x8.5 wheel with 5 or 5.5" BS as phase2 with inner fender cutouts by American Adventure Lab and Artec inner fenders.
Will be running these 38's for a few months up to a year, see any issues with this set up?
Sponsored