I've seen a lot of people using Dremels and such to do this. I cut mine off and found that a good sharp utility knife is much easier and leaves a cleaner edge. Take your time, and it'll turn out great.Can i just cut this piece of plastic off? Does it have a function? Just want a better look until I decide on the new bumper/stinger...
If people were really concerned about +1mpg they wouldn't have bought a jeepYou know if Jeep marketed this as an aftermarket part that would increase your MPG by 1 these would be flying off the shelf. Since its on there from the factory everyone wants them out.
Clearly you completely missed the point.If people were really concerned about +1mpg they wouldn't have bought a jeep
I dont think I did, these wouldn't be flying off the shelf.Clearly you completely missed the point.
You know if Jeep marketed this as an aftermarket part that would increase your MPG by 1 these would be flying off the shelf. Since its on there from the factory everyone wants them out.
Why do I feel like Foghorn Leghorn in a cartoon. “It was a joke son, a joke”.I dont think I did, these wouldn't be flying off the shelf.