hazylogic
Well-Known Member
- First Name
- Michael
- Joined
- Jul 10, 2020
- Threads
- 8
- Messages
- 120
- Reaction score
- 164
- Location
- Austin, TX
- Vehicle(s)
- 2017 Renegade; 2021 JLUR on order
- Thread starter
- #1
I had a shop install a Tazer today with my lift/tire size upgrade. It was showing a DTC U0168 code when I got it home. Looked around online and I tried clearing it, and doing a reboot of the Tazer, and that's gone now. However, when I put it in run mode (ignition on, but not running), the CEL is solid, then will flash a fe wtimes, then goes back solid. When fully running it is not lit.
I know the CEL was solid in run mode previously. What I don't remember if it did this little flashy thing for a bit. Is that normal? There's no other codes.
I know the CEL was solid in run mode previously. What I don't remember if it did this little flashy thing for a bit. Is that normal? There's no other codes.
Sponsored