ekim
Well-Known Member
- Thread starter
- #1
It looks like there's lots of room in the tail light area. Thinking about adding relays (vs diodes) and rolling my own. I'm wondering if anyone has seen just pigtail ends for the OEM tail lights and license plate light.
The Mopar solution looks good, but I fear an inability to be able to replace just a part of the system if something goes bad.
A relay like this: https://www.delcity.net/store/NC:NO-ISO!280-Micro-Change-Over-Relay/p_931794.h_931796 should be able to be used to switch between being controlled by the tow rig vs by the jeep.
I found this thread, which I think shows the plugs and pins needed: JL taillight plug but was hoping to find plugs already assembled with pigtails.
The Mopar solution looks good, but I fear an inability to be able to replace just a part of the system if something goes bad.
A relay like this: https://www.delcity.net/store/NC:NO-ISO!280-Micro-Change-Over-Relay/p_931794.h_931796 should be able to be used to switch between being controlled by the tow rig vs by the jeep.
I found this thread, which I think shows the plugs and pins needed: JL taillight plug but was hoping to find plugs already assembled with pigtails.
Sponsored
