synergy swaybar link disconnect JL

[edzel14k]

Hello guys,

just like to know anyone installed the synergy sway bar link disconnect, having problems with the bracket to install it as instruction says have to cut the spring pad a little portion get the screw. problem is too much hassle to remove the spring pad as i will need to remove the coil spring.

suggestion would be much appreciated thanks!

Sponsored

 

[jdhunt0]

I assume those are the same brackets that come with their lift? I know mine were a tight fit and I probably had the springs out when I installed them. I am putting the Synergy disconnects on this weekend as well. Good luck.

 

[edzel14k]

I assume those are the same brackets that come with their lift? I know mine were a tight fit and I probably had the springs out when I installed them. I am putting the Synergy disconnects on this weekend as well. Good luck.

i bought the bracket separately, I have dynatrac enduro 2 inch lift, i dont have any relocation bracket fro trackbar just stock.

trying to figure if i can cut it without removing the pads. as the screw hole is blocking pad

Sponsored