I ordered the same decal. Was it hard to install?Added hood and side vents decals from pixeldecals and front alien sun shade
No spacers just the wheels.Querstion: I just got 285/70/R17 new Tires ( General Grabbers) for my JLUS and I was looking at these wheels + spacers. I wanted to get spacers to give that small extra bulge ,but as I am doing research i understood that no need for that since these wheels have 4+ inches of backspacing and would give that look without it.I just wanted to confirm since you have it.Did you place any spacers on yours or is that how it will look.Could not find this Color, tyre, Wheel, stock lift pic anywhere. Thanks
I really like those steps. Do they fit on with the stock Rubicon rails or do you have to remove them?Just finished installing EAG slider/steps and RC spare tire relocation bracket to get ready for 35s and a lift tmrw. I highly recommend investing in an induction bolt heater. Alot of people have been snapping off the front body bolt because it's has red loctite on the threads. The induction bolt heater softened the loctite and bolt just screwed right out no problem.
not really,take your time, i applied the black on the red before applying on the jeep.I ordered the same decal. Was it hard to install?
Did you put them both on wet?not really,take your time, i applied the black on the red before applying on the jeep.
You have to remove the Rubi rails. I love the look and they're sturdy as heck. I weigh 230lbs and I was jumping up and down on these after install and they didn't budge. The Rubi rails weigh 26lbs each and the EAG ones 35lbs each so I'm only adding 18lbs.I really like those steps. Do they fit on with the stock Rubicon rails or do you have to remove them?
yes i did, i used some windexDid you put them both on wet?
I love the Jeep you have. Build it as needed. Enjoy!!With the exception of trailer tow/HD electrical and rock sliders, my 2-door Sport is about as vanilla as they come...but Sting-Gray nonetheless!