Smoked Turn Signals recommendations?

[TX_Ovrlnd]

Some nice options there. I don’t think I’m going to go the fender chop route (but looks good). The second factory looking light…I wonder if you can use a different side marker or if they attached? Reading on the website but not clear to me

It doesn't look like it is held on by much, could possibly replace it with the clear marker and tint that one or find a tinted one and swap it out. The pictures on the site don't show me a good enough angle to verify.

Sponsored

 

[Njdan]

Interesting. Wonder how you install? Apply some heat?

They are very easy to install. They go on dry and you use a heat gun on low and it shrinks them slightly to fit perfect.

 

[Njdan]

You can always try these.

https://www.cruxmoto.com/product/crux-motorsports-turn-signal-overlays-for-2019-jeep-gladiator/

That's the one I use and no issues. They go on easy and look good.

 

[Sholmberg0311]

That's the one I use and no issues. They go on easy and look good.

You were the reason I knew about them lol.

 

[autogaragepapi]

They are very easy to install. They go on dry and you use a heat gun on low and it shrinks them slightly to fit perfect.

They look great. Did you go with the dark or light smoke?

 

[Njdan]

They look great. Did you go with the dark or light smoke?

Light smoke

Sponsored