smokinjeep
Well-Known Member
- Thread starter
- #1
I have the H2O and JCR mounting plate. The control box rubs the grill. Anyone else with this problem? I have it mounted in the middle of my winch.
Sponsored
I think you (and the OP) mean X20 not H20, and yes I also have it along with the Rusty’s plate and no clearance issues with control box or cables.I had no issues with the H20 and the Rusty's winch plate.
Did you have the original flat plate, or the newer slanted one? My cables are also too tight and I mounted the box to the side of the bumper.I had no issues with the H20 and the Rusty's winch plate.
You’re right. I have the X20I think you (and the OP) mean X20 not H20, and yes I also have it along with the Rusty’s plate and no clearance issues with control box or cables.
I bought it Jan of ‘18. I don’t recall it being slanted when I installed it.Did you have the original flat plate, or the newer slanted one? My cables are also too tight and I mounted the box to the side of the bumper.
Have look at https://www.jlwranglerforums.com/forum/threads/rusty’s-winch-plate-question.24587/
No , they immediately go to the side and the winch line comes out the bottom so no worriesWell it already rubbed some paint off. O well. I’m going to flip the box I think or perhaps dremmel the edges of the solenoid box so it fits
Thanks for the tip to flip the box. Didn’t think of that. I take it you don’t have any issues with the wires getting in the way of operating the winch?
Could you please snap a photo with your phone? ThanksNo , they immediately go to the side and the winch line comes out the bottom so no worries