drick
Well-Known Member
- Thread starter
- #1
Coming over here from another forum, hoping build thread here doesn't require that i am the one building. Looks like a lot of you are handier with tools than i am.
5 years after my entry into Jeep land, the original rig I wanted is about to become a reality - my 2nd build thread is OPEN! New truck has been "named" and ETA is likely for mid Q1 - pending on what happens with COVID.
This was my original intent on the order:
Learning from my mistakes on my 2016 JKUR my original upgrade sequence was intended to go something like this:
Phase I
5 years after my entry into Jeep land, the original rig I wanted is about to become a reality - my 2nd build thread is OPEN! New truck has been "named" and ETA is likely for mid Q1 - pending on what happens with COVID.
This was my original intent on the order:
- 2021 JLUR
- 3.0l Diesel / AT
- Body color HT / Mopar headliner
- Mopar hinge gate reinforcement
- Integrated off road camera
- LED lighting
- Trailer / tow HD electrical group
Learning from my mistakes on my 2016 JKUR my original upgrade sequence was intended to go something like this:
Phase I
- Trek Armor / Bartact seat covers
- Weathertech floor mats
- ARB storage drawer system for rear
- Prewire the ARB wiring harness for my frig when the drawer goes in
- Tuffy underseat drawers for both front seats
- Lift kit - doing something prepackaged this time and that includes shocks - more on this later
- Hutchinson Rock Monsters & BFG KM2's - 37's again
- Full Rock Hard skid plate system - steel again
- AEV Procal
- Regear to 4.88's again (if pumpkin geometry is the same)
- New HD diff covers F&R
- New HD drive-lines F&R
- Metalcloak complete overland fender / rock slider kit
- If they have vented internal fenders will use theirs - if not will use the poison spyder
- LOD shorty bumper F
- Maybe LOD shorty bumper with rear tire carrier + jerry can mounts - more on this later
- Another shorty Rigid LED light bar for F bumper
- Warn Zeon 10s Platinum
- ARB dual air compressor - this time likely under rear passenger seat and will do a custom mount so the seats fold down flat
- Either add second battery & a better battery isolator than used on Artemis -or- look at pulling the OEM battery and replace with a Optima or maybe go LiioN
- SPOD to control all the wiring
- Full RockHard cage - including sides and 3rd row again
- HAM radio install on the cage - likely something custom this time
- Shorty firestik antenna install / wiring to to the rear bumper
Sponsored