Strikeeagle345
Well-Known Member
- Thread starter
- #1
Hey everyone. I purchased the front only pack of the Rokblokz mud flaps and tried installing them today. However, the top outboard hole does not line up with the push pin hole on my wheel well fenders (circled in the install video screenshot below). The other two lineup fine. Note, I did remove the cutout for my rock slider rails, fit just fine there.
I also notice that my outboard vertical edge (outline below from the install video) does not sit inside of wheel well fender like in the video. it sticks behind and is not able to move to the inside. Any ideas? Do I need to reach out to Rokblokz?
I can take pictures of my issue tomorrow if anyone needs it to better understand what I am reference. Thanks for the help in advance.
I also notice that my outboard vertical edge (outline below from the install video) does not sit inside of wheel well fender like in the video. it sticks behind and is not able to move to the inside. Any ideas? Do I need to reach out to Rokblokz?
I can take pictures of my issue tomorrow if anyone needs it to better understand what I am reference. Thanks for the help in advance.
Sponsored