zshowket
Member
- First Name
- Ziyad
- Joined
- Mar 20, 2019
- Threads
- 7
- Messages
- 22
- Reaction score
- 20
- Location
- Northern Ca
- Vehicle(s)
- 2019 JLU Wrangler & 2008 Rubicon 2 Door
- Vehicle Showcase
- 2
- Thread starter
- #1
As a number have before me, I got tired of the anemic back up lights on the JL. I installed 4 flush mounted rigid ignite series lights. These are the flood diffused versions that come in packs of two as a back up light kit. Let me tell you, 2 would have been plenty, but more is better. I am aware of the fact that a couple of good trips down the trail will potential destroy the lights in the center, but time will tell.
I installed these without removing the bumper. Just measure 5 times and you can do it. Drill the outside from the underneath, there is a target so you can get the drill in the center. The punch out the larger hole from the back.
I powered them off the rear power outlet and used a trigger wire from the factory rear tail light to a relay- it is white with a light brown stripe. I did get this information from here as well. By doing this there is no interference from any other sources into the factory system.
I installed these without removing the bumper. Just measure 5 times and you can do it. Drill the outside from the underneath, there is a target so you can get the drill in the center. The punch out the larger hole from the back.
I powered them off the rear power outlet and used a trigger wire from the factory rear tail light to a relay- it is white with a light brown stripe. I did get this information from here as well. By doing this there is no interference from any other sources into the factory system.
Sponsored