nU7OuxIx
Well-Known Member
- Thread starter
- #1
I received my RhinoRack installation kit this past week and during shipment, it must had been bounced around a lot. When I opened the box up, I saw that there are two rubber mat pieces that were stuck to the cardboard box on the inside.
I think these are stuck to the rollbar casting part, but not 100% sure. Is it possible for somebody to take a picture of this part so I know how these rubber mats should be applied?
Thanks in advanced!
I think these are stuck to the rollbar casting part, but not 100% sure. Is it possible for somebody to take a picture of this part so I know how these rubber mats should be applied?
Thanks in advanced!
Sponsored