Naw, my DPF is constantly cloggedThe plus side is that your exhaust will stay clean and oil pressure stable
I challenge you to link a set for the Dana UD 60 RearNot crazy. 4.30 is what Iâm thinking for 40âs. If you search Dana Super 60 4.30 R&P. Dana does make them in the 10â version. Nitro also list them as 10â. Other manufacturers/Dana will also have the more common 9.75â in 4.30.
After having 4.88 and 40âs Iâm thinking 4.30 would be the perfect gear for 40âs and the EcoDieselNot crazy. 4.30 is what Iâm thinking for 40âs. If you search Dana Super 60 4.30 R&P. Dana does make them in the 10â version. Nitro also list them as 10â. Other manufacturers/Dana will also have the more common 9.75â in 4.30.
I put in the tire size on my door sill and actual height of my 40âsI found this site for the calculation, not sure how reliable it is but for the scenario asked in the question, it says 4.22
https://tiresize.com/gear-ratio-calculator/
https://www.nitro-gear.com/Dana-60-Nitro-Ring-Pinion-p/d60-430-ng.htmI challenge you to link a set for the Dana UD 60 Rear
fusion offers 4.30 with their 60 rear.I challenge you to link a set for the Dana UD 60 Rear
https://www.yukongear.com/productdetails.aspx?ProdID=3710I challenge you to link a set for the Dana UD 60 Rear
https://www.strangeengineering.net/product/hoosier-dana-60-4-30-standard-for-3-series-carrier.html/I challenge you to link a set for the Dana UD 60 Rear
You have an issue , maybe an injector . Mine has been 50% or less for awhile .Naw, my DPF is constantly clogged
I wish I could force it to regen
Thereâs no codes or anything. I only know because Iâm running 2 banks gaugesYou have an issue , maybe an injector . Mine has been 50% or less for awhile .
Thank you, I saw those and the Yukonâs but it wasnât clear if they fit the UD60. Although I believe they will. The spline count is correct etc.
US Gear also makes a standard cut 4.30.Thank you, I saw those and the Yukonâs but it wasnât clear if they fit the UD60. Although I believe they will. The spline count is correct etc.
Now the only question is Nitro or Yukon gear?..
Anyone care to chime in here?
Iâm leaning towards Nitro...
Thank you so much!!!! This link is actually incredibly helpful and will totally help me find the right pets before I buy them!US Gear also makes a standard cut 4.30.
this link may help with verifying what is actually in your UD60, (more than ratio and locker type) by following the BOM stamped on the axle you can verify carrier, bearings, shims etc. Dana has a similar tool too, not user friendly.
https://www.axlebuilder.com/index.html