- Joined
- Jun 30, 2019
- Threads
- 27
- Messages
- 728
- Reaction score
- 551
- Location
- Water over dirt planet
- Vehicle(s)
- JLUR RHD 3.6
- Banned
- #16
Looks good but have a question...Hate running wires through the firewall, buying fuses and relays, or drilling holes in your dash? Stop spending money on expensive wire harness that are a pain to install and get your hands on one of Quake LED’s new lighting controllers while supplies lasts! This patent pending universal controller is the ultimate installation headache saver because it eliminates the need to run any wires through the firewall of your vehicle! Just connect the controller to your battery and then tie your lights or other accessories straight to the module and operate them with a remote control. Not only will it eliminate the need to pass wires through the firewall but the remote control will allow you to turn on and off your accessories while remaining outside of the vehicle providing extra functionality. The controller is rated for 60amps and should be the perfect accessory switch solution to most builds. It retails at only $99.98 making it one of the most affordable switch systems in the market and is the go to solution for anyone adding even just a couple of accessories to their vehicle.
Get yours from Quadratec, Northridge 4x4, Meyer, Keystone
Or Buy here: https://www.quakeled.com/product/universal-60a-8-led-light-controller to get your hands on one today!
If someone else nearby has the same unit, what are the chances of their remote getting picked up by my vehicle? Like is there a set number of frequency channels (assuming it's radio)?
How secure is it in this sense because I can imagine quite a bit of trouble if devices turn on or off without my control.
Thanks
Sponsored