NEED HELP ASAP: WIRED WARN WINCH AUX SWITCHES NOT WORKING

[Blu bi Kong]

There are also the 40 amount fuses. Light green tops. One of them may be blown. You can visually check them or use a voltmeter...

Sponsored

 

[Brew211]

The aux switches can't carry enough amps to power a winch the wire is too light, has to be connected directly to the battery with the heavy gauge cables.

I used the Warn power interrupt kit, so it should be good. Power in to the Warn solenoid, power out to the battery with equal gauge wire.

 

[Brew211]

I just don't have power to the switches, the lights won't turn on when I push them.

 

[Blu bi Kong]

I just don't have power to the switches, the lights won't turn on when I push them.

As far as I know there is not one fuse that will kill all 4. My help is limited to not being there with a voltmeter. Sorry

 

[SmartStopStart.com]

I just don't have power to the switches, the lights won't turn on when I push them.

Check fuses 72 and 98, both 10 Amp fuses.

 

[Brew211]

Check fuses 72 and 98, both 10 Amp fuses.

Both are good....

 

[TimmH]

if all 4 switches quit working, could it be something with the ground?

 

[SmartStopStart.com]

Try selecting switch options through Uconnect to both Battery and Ignition modes and see if results are the same.

 

[Brew211]

Try selecting switch options through Uconnect to both Battery and Ignition modes and see if results are the same.

Thank you everyone for your help. Another member suggested that I may have swapped the switch and ground on the solenoid which I did. I swapped them back but unfortunately no change which leads me to believe that I blew something. Still need help. Suggestions

 

[jungloewe]

i have exactly the same issue, what was the solution?

Sponsored