MandKM
Well-Known Member
You’re too modest. I didn’t realize that the 4-door had three anchor points per side. The 2-door only has two, so I’ll have to see if I can install a Riv-nut or two towards the forward edge.Thanks. Pretty easy, just made a paper template and transferred it to 3/4” plywood. Covered it with a spray can bed liner and used the 6 factory tie down bolts to secure it. The fridge slide is a manufactured part and the hatch is a marine hatch I found on Amazon to access the cubby.
Is the fridge slide specific to the manufacturer?
Sponsored