Metalcloak rear bumpers for JL?

[Aonar]

On my @Metalcloak JL Wrangler Crawler "Narrow Width" Rear Bumper install, I had to add extra length onto the spare tire bump stop. Here is the write-up. You can see from this 1st pic the insert that I used. After the pic was taken, I swapped it out for a black one and it looks quite stock if you even care. This is with the stock Rubicon tire and spare tire bracket.

Sponsored

 

[CloakedWillys]

What’s the weight of the rear full length bumper. Can’t find it on the site.

It runs about 70lbs

 

[Bulletbill]

It runs about 70lbs

Awesome, thank you!

 

[SaltyWet]

On my @Metalcloak JL Wrangler Crawler "Narrow Width" Rear Bumper install, I had to add extra length onto the spare tire bump stop. Here is the write-up. You can see from this 1st pic the insert that I used. After the pic was taken, I swapped it out for a black one and it looks quite stock if you even care. This is with the stock Rubicon tire and spare tire bracket.

How long is this extended piece? I have the teraflex alpha and had my tire pressed against the carrier to eliminate vibration. With 37s and 4.5 backspacing not sure if it will fit... Thanks.

 

[Aonar]

How long is this extended piece? I have the teraflex alpha and had my tire pressed against the carrier to eliminate vibration. With 37s and 4.5 backspacing not sure if it will fit... Thanks.

2 1/4 or 2 5/16ths depending on the angle I look at it...IF you are asking about the width of the red arrow area.

 

[SaltyWet]

2 1/4 or 2 5/16ths depending on the angle I look at it...IF you are asking about the width of the red arrow area.

Thanks! Yep asking about the red arrow area.

Sponsored