JLUR MetalCloak 2.5 and 3.5 Door Frame Height

[MarkY3130]

Did you all Metalcloak, they are really good at customer service and helping you through what may be going on. FWIW here are my 3.5" springs.

I didn’t call and this was a long time ago on mine. Got it all dialed in and haven’t looked back.

I like the paint markings on your bolts, not many DIY installers have that discipline. I myself have been inconsistent with it on mine

Sponsored

 

[PacNWJLGecko]

So what is the overall height on 37s with the 3.5 inch lift?

 

[MarkY3130]

So what is the overall height on 37s with the 3.5 inch lift?

Really depends on how much weight you add to your Jeep. Mine is ~77.5” tall. My garage page shows what’s on it.

 

[AZRubicon]

I didn’t call and this was a long time ago on mine. Got it all dialed in and haven’t looked back.

I like the paint markings on your bolts, not many DIY installers have that discipline. I myself have been inconsistent with it on mine

I mark every bolt no matter who does work on the rig. I slide under it after every weekend run to check them. Anal, yes, safe you bet!

 

[Teflon4xe]

Just a question. I noticed my 4xe sat stock with front fender at 40", rear fender at 40.25.



Just got Metal Cloak 3.5" installed rear sits at 43 front sits at 44". When I look at photos I see this alot. The Metal Cloak lifts sit the front higher than the rear.

So rear I got total of 3" front 4"....

If this what everyone is seeing? And anyone measured?

Thanks in advance.

Sponsored