JLUR Ecodiesel block heater plug installed in front bumper

TJ_HOOKER

Active Member
First Name
Jeff
Joined
Jan 30, 2021
Messages
35
Reaction score
49
Location
Ontario Canada
Vehicle(s)
2021 JLU Rubicon Ecodiesel
Thought I’d share, recently installed this Rugged Ridge bumper and winch and found there was plenty of room for a NOCO block heater receptacle. Like a small extension cord it has a male end under the tethered cap and a female end on the roughly 18”cord out the back. Pretty slick, and apparently there is one with a longer cord but I found I could get the OEM block heater cord to the bumper taking the grill off and fishing it down. The cord that comes out the back is out the side of its housing keeping rear protrusion to an inch or so. A little dielectric grease and some self vulcanizing rubber tape to seal the cord plugged in to one another and all set.​
56A8E74A-E4E4-4290-88E4-E429E1D43FF6.jpeg
1303D37D-45E5-49A0-81A1-4666DC26C373.jpeg
270A1B57-E8EA-463E-B1C9-8136AE94DDF1.jpeg
4D3BC7E4-B732-4478-A657-F5ADA464C149.jpeg
 
Last edited:
Advertisement

Chrysler Factory Warranty
 
Advertisement
Top