dannko
Well-Known Member
- First Name
- Dan
- Joined
- Aug 14, 2018
- Threads
- 21
- Messages
- 143
- Reaction score
- 60
- Location
- Bee Cave TX
- Vehicle(s)
- 2018 Rubicon JL Unlimited
- Thread starter
- #1
Sponsored
Can somebody PLEASE take an accurate picture of where to check castor on the JL?
These two holes?
You see the two holes on either side of the diff cover. Measure that.
No, the part circled in green here. The surface there is machined flat and you can put an angle finder on them accurately.These two holes?
Ah ok, I was wondering how you'd use the two holes I circled lolNo, the part circled in green here. The surface there is machined flat and you can put an angle finder on them accurately.
Welcome!Ah ok, I was wondering how you'd use the two holes I circled lol
Thank you!
Just in case anybody wants to know why the Dana axle has those holes , it’s for a case spreader. It has two pins that spreads the case open to change the carrier.Ah ok, I was wondering how you'd use the two holes I circled lol
Thank you!
In this scenario is your caster 1, 6, or 7?I just have an angle finder, but I'm at about 7 degrees on the knuckle and 1 at the pumpkin. Someone abo ve suggested adding 6 to the pupkin, which approximately matches what i see.