Jeep JL Wrangler Wiring Diagrams

[bratsch]

Nevermind.....found it. Thought i'd share (since a few asked for it in earlier parts of the thread).

Sponsored

 

[ALRUI]

Nevermind.....found it. Thought i'd share (since a few asked for it in earlier parts of the thread).

Where did you end up finding it if I may ask?
Thanks!

 

[bratsch]

Where did you end up finding it if I may ask?
Thanks!

Asked a buddy with dealership access to grab it for me. Took a little bit but wanted to ask here first (don't like using them much as they have their own work to deal with).

 

[ALRUI]

Asked a buddy with dealership access to grab it for me. Took a little bit but wanted to ask here first (don't like using them much as they have their own work to deal with).

Nice, my son works at Ford so I can get the Ford stuff but it's the same situation, can't push the favors to much

 

[DirtInMyRims]

Any Luck with getting this updated? It does not have the 3.6 E-torque info anywhere. Thanks!

 

[PA4xe]

Hey guys....do anyone knows where I can tap the horn output (-) for an alarm on a 2022 4xe
Thank you

 

[MyKeg]

So, what exactly is the Power Distribution Center - Auxiliary.
I have it in my 2018 JLU 2.0 but I can't figure out what it does/what it powers.

 

[ALRUI]

So, what exactly is the Power Distribution Center - Auxiliary.
I have it in my 2018 JLU 2.0 but I can't figure out what it does/what it powers.

If I recall thats for the Aux switches.

 

[motorsports_3]

Nevermind.....found it. Thought i'd share (since a few asked for it in earlier parts of the thread).

Is it possible to get one for a 3.6L motor?

 

[mikehabl]

Is there a diagram anywhere that identifies what the n2 - n7 cables go to from the high amp fused wires on the PDC?

 

[Pramod]

Is there a diagram anywhere that identifies what the n2 - n7 cables go to from the high amp fused wires on the PDC?

I hope this helps you. It has the requested details.

 

[Pramod]

If I recall thats for the Aux switches.

No, the Auxiliary PDC doesn't power the Auxiliary Switches.
Attaching the diagram showing details(BCM and Electric Air heaters powered by PDC-Auxiliary).

 

[mikehabl]

I hope this helps you. It has the requested details.

Thanks for the diagram, that definately helps. Trying to track down why everything electrical is dead. The battery is good, and power is making it to all the high amp cables (N1-N7); but the jeep is totally dead; no horn, lights, start button doesn't do anything. But at least now I can look for the key fuses to check. Is there a way to test if the entire PDC has died?

 

[emoody007]

My Rubicon came with factory LED setup. I'm going to a no fender setup and will be using a dual LED round light with white and amber led's. The light is 3 wire - ground/amber turn/white DRL. Looks simple enough to tap the proper wires for each led, however I'm not sure what the fault sense wire is and if I should be concerned about it? Any thoughts or input would be great.

 

[Badbear0416]

Great write up as it's helping me diagnose the issues I'm having afyer hard top wire install on 2023 rubicon

I can only assume as per wiper/washer diagram it's not showing on bcm c5 pin 14 OG/VT wire...I see pin 14 on C1 ? Again I assume on a 2023 they must have changed harness or pin location for this wire? Thanks

Sponsored