Did you use this (https://www.molle-platform-solution...-jeep-wrangler-rear-overhead-molle-panel-tray) from MPS? It says it’s only for the 2-door. Your install is on a 4-door, right? Other than putting in your own riser attachment, did the install go smoothly?Molle-platform-solutions.com I made brackets and discarded side panels for mounting up high and still having total cargo area for bigger stuff.
![]()
![]()
I dont know about 2 or 4 door as I only used the main basket. The size was perfect for my application. Risers attach where soft top attaches. As I don't have a soft top that was not an issue either.Did you use this (https://www.molle-platform-solution...-jeep-wrangler-rear-overhead-molle-panel-tray) from MPS? It says it’s only for the 2-door. Your install is on a 4-door, right? Other than putting in your own riser attachment, did the install go smoothly?
Thanks!
But that is the product you used, right? I have the SOT and have no need for the soft top attachment points either. So that I understand properly, The brackets that mount to the roll bar are the ones that come with the basket, right? You just added the pieces of metal to make it horizontal, right?I dont know about 2 or 4 door as I only used the main basket. The size was perfect for my application. Risers attach where soft top attaches. As I don't have a soft top that was not an issue either.
No. I made the roll bar attachment brackets. Normally it attaches to the hard top mounting bolt locations. I didn't use the included side molle panels.But that is the product you used, right? I have the SOT and have no need for the soft top attachment points either. So that I understand properly, The brackets that mount to the roll bar are the ones that come with the basket, right? You just added the pieces of metal to make it horizontal, right?