Moto_21
Well-Known Member
Comes close on the lower haha. They look so shiny too!I installed some Dynatrac balljoints
Sponsored
Comes close on the lower haha. They look so shiny too!I installed some Dynatrac balljoints
Haha yeah. That picture makes it look closer than it is!Comes close on the lower haha. They look so shiny too!
Hey Brian, When you went from the Dana 30 upfront to the UD 44, did you swap driveshafts? OR better yet was it required or did your stock driveshaft work?Haha yeah. That picture makes it look closer than it is!
Not required to get a new driveshaft. Bolts up the same way it connected to the Dana 30Hey Brian, When you went from the Dana 30 upfront to the UD 44, did you swap driveshafts? OR better yet was it required or did your stock driveshaft work?
Awesome. Thanks again for all the help. Pulling the trigger on a UD44 soonNot required to get a new driveshaft. Bolts up the same way it connected to the Dana 30
Nice!Awesome. Thanks again for all the help. Pulling the trigger on a UD44 soon
Finally pulled the trigger!! What sway bar links did you use? I have the RK Gen 1 but I don't think the brakect will work on those.Nice!
Nice! I actually just got the shortest metalcloak disconnects I could since I am local to them. So they are a little long but they work. I also had to cut the sway bar link tab/bracket off as well. I think some companies make sway bar disconnects now that don't require you to cut off the sway bar tab.Finally pulled the trigger!! What sway bar links did you use? I have the RK Gen 1 but I don't think the brakect will work on those.
Awesome thanks! I'll most likely have the ship doing the install cut the one bracket. Seems like that is the route to goNice! I actually just got the shortest metalcloak disconnects I could since I am local to them. So they are a little long but they work. I also had to cut the sway bar link tab/bracket off as well. I think some companies make sway bar disconnects now that don't require you to cut off the sway bar tab.
Just so you know you can use the jk bumpers. I just bought the v3 stubby from VickShould be a pretty sweet setup. I too am hoping VKS starts pumping out some of their front bumpers for the JL soon.
Nice! The build is always fun.Good build. Lots of good info learned a lot from your process and hope to get mine stared soon when all the parts show up.
What do you have planned?Good build. Lots of good info learned a lot from your process and hope to get mine stared soon when all the parts show up.