LCW
Well-Known Member
- Joined
- Jan 22, 2022
- Threads
- 37
- Messages
- 1,027
- Reaction score
- 1,937
- Location
- Twin Cities MN
- Vehicle(s)
- (formerly '22 JLUR) '23 Bronco Badlands 2dr 2.7
- Thread starter
- #1
Probably tough question to answer but here goes… Anyone know roughly how much to stock Rubicon jounce bumper compress in either a flexed out or bottom out condition? 1/2”? 1”? 1.5”? More?
I have a 2” Teraflex spacer kit but trying to only limit up travel as much as I need. May need to shave it down as 1” spacer kits seems to not exist. But depending on how much the jounce bumper compress at full load I may be ok with the 2” stop kit.
I have the 392 springs and shocks. At full flex (or at least until I have about a 1/4-1/2” of tire (35s) clearance to the inner fenders, I’ve got about an inch to the jounce bumper in the rear and in front might be less. I can’t see because the spring covers it when full flexed.
I have a 2” Teraflex spacer kit but trying to only limit up travel as much as I need. May need to shave it down as 1” spacer kits seems to not exist. But depending on how much the jounce bumper compress at full load I may be ok with the 2” stop kit.
I have the 392 springs and shocks. At full flex (or at least until I have about a 1/4-1/2” of tire (35s) clearance to the inner fenders, I’ve got about an inch to the jounce bumper in the rear and in front might be less. I can’t see because the spring covers it when full flexed.
Sponsored