How do I remove the doors wiring receiver under the drivers side from that bracket?

[William69]

I recently put my doors back on and seemed to have bent a pin or two in the receiver part. I just want to take the whole thing off that bracket cause it’s near impossible to get in the floorboard and straighten the pins accurately. Anyone know how to do this without breaking it?

Sponsored

 

[William69]

This is what I’m talking about in case I described it poorly

 

[Gregj]

Push the tab marked in red in the direction of the yellow arrow and slide the connector down.

 

[William69]

Push the tab marked in red in the direction of the yellow arrow and slide the connector down.

Thank you so much you're a life saver. I was able to get in there and straighten the bent pin!

Sponsored