jtjk
Well-Known Member
- Joined
- Aug 23, 2019
- Threads
- 4
- Messages
- 46
- Reaction score
- 25
- Location
- Sierra Nevadas
- Vehicle(s)
- 2019 JL Rubicon Unlimited
- Thread starter
- #1
Hi,
Spend the last few days digging through all the great info on the forum but was not able to get an answer to my issue.
I have a 19 jl with the genesis dual battery kit. I let the jeep sit for a couple of weeks and ended up draining both batteries. After jump starting the vehicle, I now have a "Service ABS" and "Service ESC" light. I cannot get these codes cleared -
- I tried taking the jeep on a few long drives to charge up the battery but the service lights remain
- I disconnected the battery entirely, but no change
- Tried to clear the codes with the tazor, but no change
- looked as a few of the fuses
What seems to seperate my issues from others is that the lights are always on... not intermittent.
Any ideas what it could be? Fuses seemed to be fine, but I did not check them all. Maybe the battery sensor?
I worry that i might have fried something when jump starting. I used a pack first and then switched to conventional jumper cables.
As a further flag the batteries were super low (2.5a) so the jeep was freaking out a little when i tried to start it (wipers going off, xmas tree on the dash, saying the vehicle was not in P when it was.
Thanks in advance for any help!
Spend the last few days digging through all the great info on the forum but was not able to get an answer to my issue.
I have a 19 jl with the genesis dual battery kit. I let the jeep sit for a couple of weeks and ended up draining both batteries. After jump starting the vehicle, I now have a "Service ABS" and "Service ESC" light. I cannot get these codes cleared -
- I tried taking the jeep on a few long drives to charge up the battery but the service lights remain
- I disconnected the battery entirely, but no change
- Tried to clear the codes with the tazor, but no change
- looked as a few of the fuses
What seems to seperate my issues from others is that the lights are always on... not intermittent.
Any ideas what it could be? Fuses seemed to be fine, but I did not check them all. Maybe the battery sensor?
I worry that i might have fried something when jump starting. I used a pack first and then switched to conventional jumper cables.
As a further flag the batteries were super low (2.5a) so the jeep was freaking out a little when i tried to start it (wipers going off, xmas tree on the dash, saying the vehicle was not in P when it was.
Thanks in advance for any help!
Sponsored